Replacing Flow Heads™

Flow devices comes equipped with two different types of Flow Heads™ Soft heads such as the Super Soft, Soft, Wide & Medium and Harder ABS heads such as the Fork, Bullet & Hammer.

While the hard heads should last a long time, care should be taken when removing soft heads, follow the simple guide below to learn how to remove and replace Flow Heads™.

Removing Hard Flow Heads™

Hard Flow Head Removal

Hold you device firmly in one hand and grip the hard Flow Head with the other, now twist the head 45° to 90° in a clockwise manner a few times to loosen the contact.

Hard Flow Head Pull

Now that the head is loosened up, just gently tug the head free, there will be a small pop as the head comes off, and you’ll be ready to insert a new one.

Removing Soft Flow Heads™

Soft Flow Head locate

To remove a soft flow head it is done as a similar manner as above, however care must be taken to only twist and pull the hard ABS plastic body of the head and not the soft foam tip.  Locate the body near the shaft and while holding you device firmly in one hand and grip the body of the Flow Head™ indicated above, twist the head 45° to 90° in a clockwise manner a few times to loosen the contact.

Replacing Flow Heads™

Soft Flow Head Replace

Replacing Flow Heads™ couldn’t be simpler, just a reverse of the removal process taking care to not bend or squish the soft heads by holding the hard body of the head as you push and twist.

Additional Information

Flow developed the standardized width of attachments, so If you are replacing your old device, it is likely that your previous heads will fit.

We recommend that you keep the hard heads clean, especially in a clinical environment by using boiling water or anti-bacterial wipes. Soft heads should be replaced approximately every 1-3 months. You can purchase them directly here

Was this article helpful?

Leave A Comment?